SNMP Base Settings

Home 

 

The SNMP services (Simple Network Management Protocol) are used for network administration. The devices support SNMP MIB II. The SNMP services are addressed via port 161. Traps are transmitted to port 162.

You can set the following parameters:

Use SNMP

This check box enables and disables SNMP.

Read-Write Community

The device can be addressed using this community.

Password Main-Community

Here you enter the password for the main community. This allows addressing all the services in the module. If no password is specified here, all stations are granted access.

Password Read-Community

Here you enter the password for the read-only access. If no password is specified here, all stations are granted read access. Write access is not permitted with this password. In that case, the Password Main-Community must be used.

This Station has Access

Here you can add further restrictions in addition to the passwords. If an address other than 0 is entered here, only the specified station is granted write access.

This Station will receive Traps

Traps are alarm triggering events for agents, e.g. a restart of the system or unauthorized access. Here you can choose the station to which the traps will be sent. If no station is entered here (value 0), no traps will be generated.